POWER SUPPLIES & CHARGERS

24 TO 12 V BATTERY CHARGING UNITS

Application in charging auxiliary batteries used to power electric winch motors, rear lift platforms and other high current drain equipment

  • electronically regulated to 14.5 V
  • current foldback under overload and short circuit conditions.
  • input to output reverse polarity protection
  • charges on a continuous basis at the unit rating which will allow a current drain of 100+ amps on an intermittent basis from the auxiliary battery
  • the unit is also designed to operate in a two battery 24 volt negative earth electrical system in maintaining the charge of a 12 volt supply battery. The unit will allow 12 volt equipment to be supplied form the centre tap of the batteries without depleting the charge in the 24 volt supply battery. 
SINGLE OUTPUT SWITCHING POWER SUPPLIES

Features

  • Low cost, high reliability
  • Built in EMI filter, low ripple noise
  • Compact size, light weight
  • High efficiency, low working temperature
  • International AC input selection
  • Short circuit/over load/over temp. over voltage protection
  • 100% full load burn-in test
  • CE Approved
  • 2 year warranty 
POWER SUPPLIES & CHARGERS

108 W & 216 W DESKTOP POWER SUPPLIES AND CHARGERS

Features

  • Low cost, high reliability
  • Built in EMI filter, low ripple noise
  • Compact size, light weight
  • High efficiency, low working temperature
  • Auto fan on/off control at 50 C (216 W model only)
  • Short circuit/over load/over temp. protection
  • Battery under/over voltage/polarity protection (ESC only)
  • 3 colout LED indication
  • 2 year warranty 
12v Laptop car power supply

regulated car & truck power adaptor
  • Features
  • · Input voltage 12v

· Output 15, 16, 18 & 20v @ 3.5A

· Output 22 & 24v @ 2.9A

· Regulated output

· Short circuit protected

· Overload protected

  • Features
  • · Input voltage 11 to 30v

· Output 1.5 ,3 ,4.5 ,6 ,7.5 ,9 & 12vDC

· Regulated output 1500mA continuous

· Stable clean DC power

· Designed for sensitive devices 

BATTERY CHARGERS

ARRID SMART BATTERY  CHARGERS

Features

  • Fully automatic
  • Easy to use
  • Full reverse polarity protection
  • Short circuit protection and current limited
  • Maintains batteries in peak condition with two stage charging
  • Safety interlock for wheelchairs, golf buggies, forklift's etc
  • with a 1 year Warranty.

12volt 10A BC1210

12volt 20A BC1220

24volt 5A BC2405

24volt 10A BC2410

The ARRIDTM smart battery charger can be used for sealed lead acid batteries or conventional deep cycle or starting lead acid batteries. Available in 12V10A and 12V20A models, or in 24V5A and 24V10A units.

Designed to Australian Standards AS3100, AS3193 and AS 3696.14.

When the battery charger senses the battery voltage is low the ARRID battery charger will boost charge the batteries. When left connected to a supply in a fully charged state the charger will only use a small charge to float charge the batteries.

The ARRIDTM smart battery charger is a three stage charger that can be permanently connected to batteries in caravans, motorhomes or yachts without fear of overcharging. 

ARRID BATTERY ROTARY

The Battery Rotary can be used to charge batteries in up to 4 different battery banks, without the need to disconnect and reconnect batteries. The Battery Rotary will charge a different battery each day, finally returning to the first battery. The duration of charging of individual batteries can be set at 6, 12 or 24 hours.

  • Features
  • Batteries not charged in parallel
  • Reduces risk of battery of sulphation
  • Available with 3 or 4 stations to charge
  • two, three or four battery banks
  • Charges single batteries in succession within
  • a battery bank or in different battery banks.
  • BROT 12 to 24 can charge 24 V batteries from
  • a single solar panel

The Battery Rotary is designed for use with solar panels, wind generators, battery chargers or car/boat alternators. The Battery Rotary removes the need to charge batteries in parallel. 

BATTERY CHARGERS

DOLPHIN BATTERY CHARGERS
  • Fully automated switchmode battery charger
  • Designed for marine use
  • Fast, safe and efficient
  • Light weight, compact size
  • Suitable for 3 banks (2 with Dolphin 1210 and 1215) with independent outputs
  • Acts like a power supply without battery
  • Three stage charging (IUoU, except 24120 and 24160)
  • Operates efficiently with dirty generator outputs
  • Temperature compensation (option)
  • Suitable for either wet or gel batteries (manual adjustment)
  • LEDS status indicators
  • Remote control panel (option, except 1210 and 1215))
  • Three years warranty (except 1210 and 1215)
  • Worldwide service